![]() The blue light on the stick will turn bright and stable. If you are connecting for the first time, search Mpow iSnap X and then tap on it to connect it. ![]() Go to settings and then connectivity and turn on Bluetooth. Make sure that your phone’s camera settings are set to being able to capture photos using the volume up (+) button.Īfter this, take your phone. The blue light on LED 1 will start blinking which means that the device is ready to be paired with your phone. Do remember that this stick is for phones and not cameras or GoPros.įirst, hold the shutter button (at the front) for 3 seconds and then release it. Therefore check if your phone is compatible with this stick, before trying to connect it. This stick is not compatible with Windows phones such as old Nokia devices, Blackberry or any other that does not have the capabilities mentioned above. These include older and newer versions of iPhones such as the iPhone 6s and the iPhone X. Besides Android, it can be used with any phone that can take pictures with its Volume up (+) button. However, you must know that the stick might not be compatible with the newer versions of these Android phones. This would include any android phone with a Bluetooth 3.0 capability and includes phones such as Samsung Galaxy devices, Samsung Note series, Moto, Droid, and Nexus. The Mpow stick is compatible with Android phones. After a full charge it can work for around 5 hours. The battery works for 300 cycles after which you have to replace it. The battery capacity is 50mAh and it takes 1 to 2 hours to fully charge this device. The red light means that it is successfully charging and when the light goes off, it means that your stick has been fully charged and is now ready for use. This could be a charging port or even your laptop.Īfter you have attached it for charging you must observe the lights. You can connect the stick to an outlet with the cable that came in the box. So, before using it for anything you should first charge it. ![]() Like many other electronic devices, your selfie stick needs to be charged before use too. For reference, LED 2 is at the bottom while LED 1 is at the front. When the red light goes off, it shows that the stick has been fully charged now. Like many similar electronic devices, this shows that the stick is currently charging. Lastly, the red light stays on and does not blick on LED 2. You can therefore use it for various functions such as capturing photos, making videos and in essence using it as a remote controller. This indicates that the device is connected successfully with your selfie stick. The second indication is the blue light stays on and does not blink on LED 1. When LED 1 blue light blinks, it indicates that your stick is in pairing mode and you can connect it to your phone or any other device through Bluetooth. There are two LEDS and they light up when the stick is performing various functions. Before you start using the Mpow stick, you should know what the different lights on it represent.
0 Comments
Leave a Reply. |